• Robert Lowreys Piano Experts Touch-Weight Adjustment Systems. Touch or touch weight refers to the pressure required to press a piano key. Too little touch weight, or touch weight that is uneven from note to note, makes a piano action difficult to control; too much touch weight makes a piano tiring to play, and can cause physical problems for the player over time. Touch-weight problems can be caused by poor action design, worn parts in older pianos, or incorrectly dimensioned replacement parts in restored pianos. Historically, discussions, measurements, and adjustments in this area of piano technology have been about static touch weight — the force needed to make a piano key just begin to move slowly downward. Less well understood, and usually ignored, has been dynamic touch weight — the force required to press a key in actual normal, rapid playing. Here, the rapid movement of the key creates inertia (i.e., the tendency of a moving mass to keep moving in the same direction and at the same speed, and the tendency of a stationary mass to remain stationary.) Unlike static touch weight, which depends on the relative amount and positioning of mass on either side of the key's balance point, as well as on friction, dynamic touch weight depends on the total amount of mass in the system. Attempts to fix problems in static touch weight by adding mass to the front or rear of the key can cause problems with dynamic touch weight by creating excessive inertia. Until fairly recently, technicians resorted to a patchwork quilt of homemade, trial-by-error remedies for problems with static touch weight; dynamic touch weight wasn't even on their radar. More recently, a greater understanding of touch weight has emerged, and more sophisticated techniques for solving touch-weight problems are being developed. The gold standard among these techniques is that of David Stanwood, who developed the first system for mathematically describing, measuring, and solving problems related to dynamic touch weight. His system is applied by a network of specially trained technicians who, because of the comprehensive nature of the system and the remedies it suggests, tend to use it on higher-end instruments and those undergoing complete restoration. More information can be found at www.stanwoodpiano.com. A simpler remedy, but only for heavy or uneven static touch weight on a grand piano, is a product called TouchRail, available through piano technicians. TouchRail is a rail with 88 individually adjustable springs that replaces a grand piano's key-stop rail. The springs press gently on the keys to the front of the balance point, enabling the technician to effectively "dial in" a desired touch weight and make it perfectly even from note to note. Because it's spring-based rather than mass-based, TouchRail won't add inertia to the action system, though of course it won't cure any pre-existing problems with excessive inertia, either. Installation requires no drilling, cutting, or other permanent modification of the piano, and the rail can be removed and replaced in seconds during routine piano service, just like a traditional key-stop rail. The installed price is around $500. See www.pitchlock.com for more information.